Quickly reflash the vehicle without the need for a PC during programming

Features:

• Non-invasive flash reprogramming through the vehicle OBDII connector
• Easy to use programming wizards
• Rapid vehicle programming and information retrieval
• Supports one vehicle, with multiple maps
• DTC Support - Read and clear DTCs for all control modules in the vehicle (this is optional at additional cost)
• Additional vehicles can be added as an upgrade (up to 3 total) 
• System includes the handheld programmer, software, and PC cable for updates

The Autotech Program Carrier handheld for the Focus RS Mk2 is a unique device with features not seen by alternative products in the market place. Supplied for the Focus RS Mk2 with Stage 1 map pre-programmed into the device for easy reprogramming of the vehicle ECU via the OBDII port. The device will also hold your OEM Ford map. Additional maps can be added at extra cost if required. This Stage is designed for the buyer who is looking for some extra power but wants all other components to remian 100% OEM

Stage 1 will show an approx. 40bhp gain* over the standard power output of your Focus RS Mk2, this is without any other modifications to your car. With the OEM map you can also put your car back to standard for any service or warranty work at your dealer.

*Power gains are genuine proven figures based on the Dynojet rolling road we tested on and with the hardware fitted to our test cars. The graph above shows figures at the flywheel. It is reasonable for you to assume that you will achieve similar gains from our product. All power gains based on our own test car , tested under strict conditions which were replicated as closely as possible in each test to ensure accuracy and consistency. Actual figures on different rolling roads may vary by small percentage up or down. Our power claims are based on the assumption your car is achieving Fords claimed power output of 305PS (approx. 300hp). Even if it is not (possibly becuase it is running an early Ford calibration) our maps will update the calibration and make improvements upto the power output advised.

ECU Notification: The ECU on the Focus RS MK2 needs to be 'BDM Enabled' prior to use. This requires you to send your ECU to us or bringing your vehicle to us for this procedure to be completed. Once enabled all further programming can be completed from the handheld device directly through the OBDII port.